Incremental sensor
IC-III
Incremental sensor IC-III is destined to read revolutions or angle with direction distinguishing.
The shaft of incremental sensor is placed in two ball-bearings. There is an electronical evaluating part inside the sensor, which generates impulses by rotating. These impulses enable to specify direction of rotating and speed. We produce electronic counter LUCA-T for evaluating the imppulses from the IC-III sensor. See the details in the LUCA-T product description and operating manual.
Technical specification
| Parameter | Value |
|---|---|
| Outside diameter of sensor | 62 mm |
| Number of electrical pulses per revolution | 1 – 25 |
| Weight | 340 g |
| Max. idle torgue | 0,15 Ncm |
| Recommended supply voltage | 15-30 V ss |
| Maximal current | 50 mA |
| Output signal | 2 x NPN open collector |
| Input pulse ratio | 1 : 1 ± 10 % |
| Pulses phase difference | 90° el. ± 10 % |
| Recommended maximum revolutions | 50 s-1 |
| Maximum output frequency | 1 kHz |
| Working temperature | -10 až +50 °C |
| Protection | IP 54 |
| Length of standard cable LIYCI 4 x 0,25 | 3 m |
Incremental sensor IC-III is produced in following variants:
- IC – III / A: standard cylindrical shaft (mounting according picture below – with hard coupling, holder and rubber bushing)
- IC – III / B: expansion cylindrical shaft (no coupling necessary)
- IC – III / C: with shaft for measuring wheel attaching
Typical application of IC-III / A
Dimensions
Dimensions of shaft boring for IC-III / B
Do you have a question? Contact us.
Ing. Václav Skalický | +420 608 380 665 | skalicky@skv-sro.cz